Aug 22, 2010 Whirlpool makes a line of clothes dryers for residential use that have electronic control panels. These electronic controls allow Whirlpool to offer a controlpanel lock feature that will disable the control panel on the dryer to prohibit changes to the cycle once the dryer is in use, or use of the dryer altogether. Your Whirlpool Duet washing machine automatically locks the door as a precaution against opening the door during a wash cycle.
If the door did not lock, small hands or preoccupied minds might open Select and hold END OF CYCLE SIGNAL for 3 seconds until the CONTROL LOCKED Status light turns off. If that does not do it, try putting the machine into diagnostic mode. How do I remove the Control Locked light which prevents starting. After the power returned from the hurrican, the Control Locked light was on. I have a whirlpool duet Jun 19, 2015 Whirlpool duet control panel locked and will not unlock If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed. View and Download Whirlpool Duet HT GHW9250ML1 use and care Whirlpool duet ht manual control locked online. FRONTLOADING AUTOMATIC WASHER. Duet HT GHW9250ML1 Washer pdf manual Unplug the washer for 30 seconds to attempt to reset the Duet washer control.
Attempt a Duet Washer Quick Diagnostic Test Check the I just looked at it in your manual to verify. Ask Your Own Appliance Question. whirlpool duet washer shows" control locked". if i hit cancel and control it shows 1: 00 minute left. any way to reset this? The" Control Locked" light is lit on my Whirlpool Duet HT Washer and the washer will not start.
Ive had my duet since 2008 and have taken good care of it recently the control locked light popped on after my son decided to play with the buttons. Because of its age the writing has faded after all its 2018 now so the machine is over 10.
Quick Answer. To unlock the control panel on a Whirlpool Duet washer, hold the End of Cycle Signal button for about three seconds. Once the Control Lock indicator light turns off, the control panel is unlocked. What to do: This may fix itself. When" Sud" or" Sd" is displayed, the washer will extend the rinse time in order to remove the excess suds.
The washer will actually pause in the middle of tumbling and add water for additional rinsing, allowing the