Home

Waterra powerpack pp1 manually

For purging larger volumes, any of the Hydrolift II, Power Pump 2, PowerLift3 or PowerPack PP1 automated pumps by Waterra can be used. Waterra actuators also make excellent water sampling instruments. Use any of the automatic actuators in conjunction with Waterra's high flow foot valves for deep well sampling with lifts up to 300 feet.

Waterra found that by eliminating complex and overengineered components like bladders, pistons and submersible motors that a low cost, easy to operate pump could be produced. The final product consists only of a foot valve and a length of plastic tubing that when oscillated up and down in the well, by the Waterra Powerpack, produces a flow of water.

The PowerPack PP1 is a fully portable, single operator power actuator for efficient and sustainable pumping with Waterra Inertial Pumps to depths of up to 85 metres in 50mm diameter boreholes. Powered by a Honda GX22 series 4stroke engine using standard unleaded fuel, this is a simple solution for improving your pumping performance with inertial pumps. Available for rentalhire, the Waterra PP1 PowerPack Inertial Pump.

Capable of pumping from depths of over 60m. Using the Powerpack PP1 on boreholes without mountable headworks The PowerPack PP1 is designed to be attached to boreholes with upright headworks to enable it to be operated without user contact. The Standard Flow System can be manually operated in most wells simply by holding the tubing by hand and oscillating it up and down in the well.

Sometimes performance and endurance can be improved with the addition of the Waterra Lever Pump (WLP 100). POWERPACK PP1 Manual& Automated Pump Actuators by Waterra USA Inc. This actuator is an excellent choice for those with moderate pumping requirements.

The Waterra PowerPack PP1 Waterra has been providing customers with Simple Solutions for Groundwater Monitoring Waterra USA Inc. POWERPACK Model PP1 Manual& Automated Pump Actuators The PowerPack PP1 incorporates clamps for Waterra High Flow and Standard tubing sizes (adaptors are available for smaller tubes). A Honda GX22 series, 0. 25 horsepower, 4 stroke, gasoline motor powers this device, which can run for approximately 1 hour without refuelling.

The PowerPack PP1 is a lightweight, petrol (gasoline) powered mechanical actuator designed for use with Waterra inertial pumps. Manually operated inertial pumps, consisting of Waterra Power Packs Waterra Power Pack PP1 The Waterra PowerPack PP1 provides the mechanical actuation for pumping with inertial pumps to depths of over 60m, Waterra Valves and Flow Systems Operate the valve manually or using a Waterra Lever Pump, PowerPackPP1 or PowerPump2 device when greater purge volumes are Waterra Power Pack PP1 Overview The Waterra PowerPackPP1 provides the mechanical actuation for pumping with inertial pumps (footvalve system) to depths of up PowerPack PP1 power& portability The Waterra PowerPack PP1 provides the mechanical actuation for pumping with inertial pumps to depths of over 60m, in a fully portable, single operator power unit.